Bohemian Biker Blog

10 AWG Application – Customer Pic’s

by on Dec.31, 2010, under Application

Check it out…  Crafty Customer, Mark Penman, assembled and installed some of our SAE 2 Pin – 10 AWG offerings to facilitate easy access to his bike’s 12-volt battery and charging system.  Not only does he now have access via higher amp capacity leads, but he saves himself the trouble of disassembly to gain that access !!!

At 12″ long, our SAE 2 Pin – 10 AWG pigtails are generally of sufficient length to extend from a bike’s battery terminals to a point of easy access.  As can be seen in one of the photos, these “pigtails” can also be used in fabricating a battery terminal clip assembly – miniature battery terminal clips available from us, as well.

We offer SAE 2 Pin – 10 AWG Extension/Jumpers in 5′, 8′, and 10′ lengths – 5′ probably being the best choice with with respect to sufficient reach and easy storage.

It should be noted that special attention needs to be paid to polarity…not only while assembling, but also upon using such assemblies.  As can be seen in photos, Mark has marked the “Hot” (+) postive lead with Red electrical tape.  We have these pigtails manufactured with black insulation on both leads – allowing the assembler to mark as needed for a particular application.

We welcome email at: bohemianbiker@bohemianbiker.com

Currently, our products are available through our new e-commerce website at:  www.solarcapitalist.com  

Solar Capitalist LLC is our sister company handling products such as those discussed above, as well as Portable Solar Chargers – Capitalize on the Sun’s Energy !

 
bb-banner-1028087

:, , , , , , , , , , , , , , , , , ,

Leave a Reply

Looking for something?

Use the form below to search the site:

Still not finding what you're looking for? Drop a comment on a post or contact us so we can take care of it!